Table of Contents
Advertisement
ID PRESET switch
This technique lets you record time code data starting from a
newly specified value.
.1. Put the VCR in the Stop mode.
2. Set the INT/EXT switch to INF.
3. Set the PRESET/REGEN switch to PRESET.
4. Set the FREE/REC switch to the desired position.
FREE:
Time code runs in real time, regardiess of VCR's
operating mode.
REC:
Timecode runs only during VCR recording.
Setting Initial Time Code/User Bit Values
e Engage the EE mode by pressing the REC button in the
Stop mode. TC generator data is displayed on the
counter.
1. Set the COUNTER select switch to TC or UB.
TC: To set the time code.
UB: To set the user bits. (When using user bits for ID,
also set the ID PRESET switch to ON.)
2. Press the HOLD bution. ©
@ The current counter data is held; the leftmost digit will
blink in the Preset mode.
3. Press the ADV (ADVANCE) button.
@ This advances the value of the blinking digit. Set to the
desired value. (You can also change the value in either
direction by holding down the ADV button and turning the
PRESET button
ADV button
SHIFT button
JOG dial.)
4. Press SHIFT.
HOLD button
® The blinking digit shifts to the right. (You can also shift the
COUNTER select switch
blinking digit in either direction by holding down the SHIFT
button and turning the JOG dial.)
5. Repeat steps 3 & 4 until all data is set.
6. Press the PRESET button.
® The preset data will be transferred to the time code
generator.
@ Inthe Free Run mode, time code starts running.
NOTES:
7. Press the STOP button to finish setting.
@ If the COUNTER RESET button is pressed during TC data
8. Proceed with recording. (c¥ p.19)
setting, the counter is reset to "00:00:00:00".
@ In user bits setting, all 8 digits can be changed from "0" to
i
eee
ees aes
Advertisement
Table of Contents
