Table of Contents
Advertisement
© TBC ON/OFF switch.
® Set to ON for TBC playback. (During TBC operation, the
servo is locked to the reference signal supplied to the EXT
REF connector even if the SYNC select switch is set to
VIDEO.)
:
® Set to OFF to bypass TBC.
@ MENU SET ON/OFF switch
e SET to ON to activate the On-Screen Menu. The counter
display will also switch to the Menu Set mode.
© Most basic system setup operations are performed using
the Menu.
@ PB Y ENHANCE switch
e Enhances the luminance signal for a sharper playback
picture.
+4 dB: Boosts luminance signal level by 4 dB at 2.5 MHz
for maximum picture sharpness.
+2 dB: Boosts luminance signal level by 2 dB at 2.5 MHz
for a sharper picture.
0 dB:
No effect. The same result is obtained by setting
the VIDEO OUT select switch @ to EDIT.
@ SYNC select switch
EXT:
The
servo
is synchronised
with the external
reference signal supplied to the EXT REF input.
VIDEO: The servo is synchronised with the input video
signal.
@ REC MODE select switch
S-VHS: To record
in the S-VHS
mode.
(Use
S-VHS
cassettes only)
VHS:
To record in the VHS mode.
@ VIDEO OUT select switch
EDIT:
Set to this position when using this VCR as a feeder
or recorder in dubbing.
NORM:
Normally set to this position.
@® VIDEO AGC ON/OFF switch
@ Set to ON to activate the built-in VIDEO AGC circuit.
e Set to OFF to adjust the luminance video recording level
manually.
@® VIDEO control
e Use to adjust video recording level, referring to the
VIDEO/TRACKING
meter. The centre click-stop is the
standard position. The VIDEO AGC switch must be OFF to
use this control.
TIME CODE GENERATOR/READER
SETTING
SWITCHES
_ (With SA-R22E
TC generator/reader installed)
@ ID PRESET ON/OFF switch
ON:
To record the ID code specifically preset for each
VCR.
OFF:
To use the user bits memory for standard procedures
in the Preset mode.
@® VITC REC ON/OFF switch
ON:
To record VITC time codes.
OFF:
VITC time codes are not recorded.
NOTE:
This switch has no effect on LTC recording (enabled by
setting menu item #206 to "01 - LTC').
@
FREE/REC switch
PRESET/REGEN switch
INT/EXT switch
AUTO/LTC/VITC switch
Test points
V-RF test point
A-RPF test point
D-PULSE pin
GND
10
Advertisement
Table of Contents
