Table of Contents
Advertisement
PLAYBACK
1. Set the SYNC select switch as required. (c= p.10)
2. Set the AUDIO
MONITOR
select switches as required.
(c¥ p.8)
3. Set the COUNTER select switch as required. (c= p.8)
4. Set the VIDEO OUT select switch as required.
NOR:
for normal playback.
EDIT:
when using the VCR as an edit feeder.
5. Set the REMOTE select switch as required. (c= p.8)
6. Set the TBC switch to ON if you are using the SA-T22E or an
external TBC.
1. Press the PLAY button.
@ Normal playback starts.
2. Check the tracking level.
@ Set the METER SELECT switch to VIDEO/TRACKING.
@ Adjust the TRACKING
control until the tracking meter
(AUD-2/R) deflects fully to the right.
@ Check the monitor screen to be sure that the picture is not
blurred or marred by noise bars.
3. Set the PB Y ENHANCE switch as required.
@ lf the VIDEO OUT select switch is set to EDIT, this switch
has no effect.
4. Press the STOP
button to stop playback.
NOTES:
@ LP recordings cannot be played back.
® To monitor the input signal during playback, press the REC
button while in the Play mode.
e Do not press the REC and PLAY buttons simultaneously,
otherwise the VCR will enter the Record mode.
The VCRis preset to enter the Stop mode at tape end. If you
want the VCR to automatically rewind when the end of the tape
is reached, set menu item #312 to "01 — REW". (cz p.29)
17
AUDIO MONITOR select switches
COUNTER select switch
REMOTE
select switch
SYNC select switch
VIDEO OUT
select switch
METER SELECT switch
PLAY button
STOP button
PB Y ENHANCE switch
| |
Advertisement
Table of Contents
