American Standard DetectLink 6072121 Manual page 9

7
INSTALL WIRE COVER: APPLICABLE WITH ASA IOT CERAMICS
Note: This step is only applicable if using ASA
IoT Ceramics
1. Insert WIRE COVER (1) through FLUSH VALVE
BOTTOM COVER (3) and SPUD COVER (4).
2. Cover the WIRE (2) with the WIRE COVER (1).
(Applicable with AC Version) Cover the AC wire
with the WIRE COVER (1) similar to WIRE (2).
Note: The Wire Cover will be loose until the
next step to secure it. Ensure that the wire
does not slip out between steps.
Note: Avoid pinching or excessively bending
the wires.
Note: If the vacuum breaker tube was cut to a
shorter length, the wire cover will also need to
be cut. Wire cover length should be from the
top of the installed spud cover to the bottom
of the valve body fixation nut plus 1/8".
Note: WIRE COVER (1) is only included in ASA
IoT Ceramics Package.
8
SECURE FLUSH VALVE BOTTOM COVER
1. Secure FLUSH VALVE BOTTOM COVER (2)
with the two SET SCREWS (1) on each side.
H
2
1
3
4
2
1