American Standard DetectLink 6072121 Manual page 6

4b
INSTALL VACUUM BREAKER TUBE: APPLICABLE WITH ASA IOT CERAMICS
Note: Step 4b is only applicable if using ASA IoT Ceramics.
Otherwise, refer to step 4a.
1. Separate HEX NUT (4) from SPUD COVER (7).
2. Thread WIRE (5) through FLUSH VALVE BOTTOM COVER
(2) and SPUD COVER (3).
3. Insert VACUUM BREAKER TUBE (1) through
the FLUSH VALVE BOTTOM COVER (2), SPUD COVER (3),
HEX NUT (6), AND HEX NUT (4).
4. Thread HEX NUT (4) on to the Toilet Base.
Note: Ensure that the O-ring is properly seated in the base of
HEX NUT (4).
Note: Vacuum breaker tube can be shortened by up to 1-1/2"
if desired.
Note: Spud Cover (3) and Wire Cover is only available in the
ASA IoT Ceramics Package.
C D
1. Slide SPUD COVER (1) over HEX NUT (2).
2. Secure SPUD COVER (1) by tightening SET SCREW (3).
H
4
7
6
2
5
1
3
4
1
3
2