American Standard DetectLink 6072121 Manual page 8

5
CONNECT VALVE BODY TO STOP VALVE
1. Push VALVE BODY (1) in to STOP VALVE (2) allowing the O-ring to seal the connection.
2. Thread HEX NUT (3) on to STOP VALVE (2) to secure the connection.
Note: Do not use pipe sealant or plumbing grease.
C
6
CONNECT VALVE BODY TO VACUUM BREAKER TUBE
1. Thread HEX NUT (1) on to the bottom of
VALVE BODY (2).
Note: Ensure that the bladder on the vacuum
breaker tube makes a good connection with
the bottom of the flush valve body.
Note: If using a wired version, ensure the
wires do not get pinched while securing the
flush valve body.
C
2
1
3
2
1