American Standard DetectLink 6072121 Manual page 14

11
INSTALL FLUSH VALVE HEAD:
Note: excess wire length should be placed in the Flush
Valve Head so that is is not pinched when the Flush Valve
Head is installed.
1. Place FLUSH VALVE HEAD (1) on to FLUSH VALVE BODY
(4) and rotate so that FLUSH VALVE HEAD (1) locks in to
KEY SLOT (3).
2. Secure FLUSH VALVE HEAD (1) with SET SCREW (2).
H
12
INSTALL WIRE CHANNEL
Note: This step is only applicable for the
AC version.
1. Thread WIRE COVER (2) in to the back
of FLUSH VALVE HEAD (1).
2. Secure ESCUTCHEON (3).
13
IMPORTANT FLUSH VALVE ACTIVATE
1. Remove IR sensor cover sticker. Test flush functionality with a single button
press (do not hold down button) and check for leaks.
2. Refer to the Quick Start Guide to complete setting up the flush valve
functionality.
3
4
1 2 3
1
2