Table of Contents
Advertisement
Commissioning (Startdrive)
8.7 Configuring the converter
8.7.2
Configuring digital inputs and outputs via technology objects
Overview
The function of the digital inputs DI 0 (≙ activate measuring probe 1) and DI 1 (≙ activate
measuring probe 2) is already pre-configured and activated.
Figure 8-13
Configuring digital inputs and outputs
Requirement
• The drive has been completely created and completely specified in the device configuration.
• For activated user management (UMAC):
The function rights required to edit the drive data are activated for your user role.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Configuration Manual
109810578).
Procedure
Proceed as follows to configure digital inputs and outputs:
1. If you are not using any measuring probes, you can deactivate them manually using the
check box.
Measuring probes are generally available. The default setting is correct in these cases.
2. In the drop-down list "Activate equivalent zero mark", select whether you wish to use an
external zero mark and whether this external zero mark should apply for DI 0 or DI 1.
3. If required, you can assign a function for each digital input/output using the drop-down list.
4. Save the project to apply the settings.
278
(https://support.industry.siemens.com/cs/ww/en/view/
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
