Control And Technology Object; Inserting A Simatic S7 Controller Into The Project - Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual

Result
The motor placeholder is assigned the data of the selected motor. The white area turns gray.
The motor has been added. The assigned encoder and the encoder evaluation are
automatically also added and specified.
You can then carry out the basic parameterization (Page 276), or alternatively, you can carry
out the guided quick startup (Page 253).
8.5.2

Control and technology object

8.5.2.1

Inserting a SIMATIC S7 controller into the project

Overview
If, in addition to the SINAMICS drive, you also wish to use a SIMATIC S7 controller in the device
configuration, then create an appropriate PLC in your project.
Note
Other control systems
As an alternative to a SIMATIC S7 controller, a SINUMERIK ONE or a SINUMERIK MC can be used.
The procedure remains the same.
Requirement
• A new project has been created or an existing project is open.
• For activated user management (UMAC):
The function rights for editing drive and control system data are activated for your user
account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Configuration Manual
109810578).
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
8.5 Combining and configuring devices in the project
(https://support.industry.siemens.com/cs/ww/en/view/
Commissioning (Startdrive)
243