Corrective Maintenance; Service And Maintenance For The Converter; Restoring The Converter To Factory Settings; Restoring Factory Settings Via A Commissioning Tool - Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual

Corrective maintenance

13.1

Service and maintenance for the converter

13.1.1

Restoring the converter to factory settings

13.1.1.1

Restoring factory settings via a commissioning tool

Description
The restoring to factory settings with a commissioning tool (web server, Startdrive) only deletes
the user-specific parameterization of the converter, for example motor data.
The following settings are retained with the restoring:
• Activation and settings of User Management & Access Control
• The "IP configuration" and "Device name" communication settings of the service interface
(X127) and PROFINET interface (X150)
• Installed firmware on the converter
The restoring to factory settings with the commissioning tool is described in the following
sections:
• Web server: Restore factory settings (Page 207)
• Startdrive: Restore factory settings (Page 306)
13.1.1.2

Reset of all user-defined settings to the factory setting via an SD card

Overview
The following user-defined settings are stored in the converter:
• Parameterization of the converter
• Activation and settings of User Management & Access Control
• "IP configuration" and "Device name" communication settings of the service interface (X127)
and PROFINET interface (X150)
• Self-generated certificates
• User-defined parameter lists in the web server
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
13
587