Honda CB200 Shop Manual page 32

28 llI. ENGINE
2 Replace any gear showing excessive wear
or
damage.
Also check the gears for smooth sliding on the shaft
splines
Assembly
I.
Install the
ball
bearing set ring
and knock
pin ro the
upper crankcase. Install the mainshaft and countershaft
with the bearing groo"es and piJl holes fitted to the set
rings
and
guide pins
2 Rotate each shaft by hand lo see if it rotates freely
without binding
f ig.
3-49 (I)
Ball bearing set ring
(2) Knock pin
fig. 3-50 (I) Mainshaft (2) Countershaft