Table of Contents
Advertisement
In this mode, the delay signal is used for feedback, and the
One-point advice
auto-panning function is carried out on the resulting signal.
By using different sources (for example strings in channel 1,
harpsichord in channel 2) and slowly carring out auto-panning,
Basic parameters
an impressive effect can be achieved. The following values
0—1001msec (CHI, 2)
may serve as a guideline.
0—255msec (CH1, 2)
0.01—0.99 (CH1, 2)
0.000 —+0.992 (CH1, 2)
designates the phase (set with PHASE)
0.000—1.000
010—20.00Hz
REN. T. (Delay T)
30—150msec
20—50msec
0.40—0.80
0.500—0.804
| SPEED
| 0.50—0.80Hz
When the same signal is used in both channels, different REV.
DRY
T. and PRE. DT settings should be chosen.
g
rN]
=
z
a
30—150msec
CH2 | 80—200msec
20—50msec
30—80msec
REV. Ti, 2
REV. 11,2.
~Jime
PRE. DTI, 2
REV. TH, 2
REV. Tt, 2
(DELAY T)
CHI
x=
a,
For organ, setting DEPTH to "1.000" and SPEED to about "8"
CH2
= 8
and applying suitable REV. T. and FBL, a tremolo effectcan be
2
produced.
Panning characteristics ——~* DEPTH: 1.000
Notes
7227 DEPTH: 0.500
¢ If the same signal is present in both channels and the same
settings are chosen, auto-panning will have no effect.
In this mode, stereo operation is chosen automatically,
regardless of the position of the STEREO/MONO indicator.
INPUT?
ae
PRE. DTI
)
RT HIGHt
PRE. DT2
RT HIGH2
Block diagram of auto-panning function
Advertisement
Table of Contents
