Table of Contents
Advertisement
Basic parameters
0.90—9.90sec (CH1, 2)
4—572msec (CH1, 2)
41—572msec (CH1, 2, 3, 4)
0.000—-+0.992 (CH1, 2, 3, 4)
+designates the phase (set with PHASE)
0.01i—0.99 (CH1, 2)
1—16
Setting to 16 produces same effect for channels 1
and 2
Level
One-point advice
The setting for mode 7 is practically the same as for mode 2
(plate reverberation), except for the fact that there is no
crosstalk between channels.
SPREAD cannot be set for the channels independently. In
ordinary use, it should be set to "16" for identical results in
both channels. By selecting a value of "15" or lower, a slight
stereo effect can be produced.
ORY
E. RFL.
L3,
4
Time
Basic parameters
0.90—9.90sec (CH1)
REV. T.
0.1—99.0sec (CH2)
1—572msec (CH1)
PRE. DT
1—850msec (CH2)
4—572msec (CH1)
E. RFL.T.
1—850msec (CH2)
0.000—+0.992 (CH1, 2)
E. REL. L.
+designates the phase (set with PHASE)
RT HIGH
0.01—0.99 (CH1, 2)
1—16 (CH1)
SPREAD
1—12 (CH2)
GATE
1—300msec (CH2)
One-point advice
By using cascade connection (channel 1->channel 2 or vice
versa), special effects can be created.
= Level
Cc
Time
Time
RT HIGH2
PRE. DT2
Advertisement
Table of Contents
