Range Setting; Selecting Scan Codes - Omron F3S-TGR-CL2 Installation And Operation Manual

Range setting

6-4 Range setting
!WARNING
6-5

Selecting Scan Codes

Operating range is set using switches 1 and 2 on the transmitter. Please refer
to the table for valid switch position settings.
1 2
4
Never use a long range light curtain for distances under the operating range.
Failure to do so may cause serious injury.
The F3S-TGR-CL receiver and transmitter offer scan code selection to mini-
mize cross talk.
Note Both receiver and transmitter must be set to the same code.
Example:
Sequence to activate Scan Codes:
1 2
TX/RX
3
1 -> ON SHORT RANGE SELECTION
2 ->OFF
1 -> OFF LONG RANGE SELECTION
2 -> ON
TX
5
RANGE:
RANGE:
Scan Code A
Scan Code B
3 4
Connect white wire
of TX to pink wire of
RX SLC
Section 6-4
LONG RANGE
SHORT RANGE
5
all LEDs 1 time =
CODE A
all LEDs 2 times =
CODE B
15