Table of Contents
Advertisement
Installing and Setting up the Machine > Network Setup
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
2
3
4
5
IMPORTANT
You can connect up to three handheld devices at the same time using Wi-Fi Direct setting. When the devices
that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already-
connected devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
Select [Home] key > [Task Screen] > [Wi-Fi Direct] > [Connected Device List] > [Disconnect All]
• Configuring auto disconnecting time from the System menu
Wi-Fi Settings (page 8-27)
• Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
Display the screen.
[System Menu/Counter] key > [System/Network] > [Network] > [Wi-Fi Direct Settings] >
[Wi-Fi Direct]
Configure the settings.
[On] > [OK]
Restart the network.
[System Menu/Counter] key > [System/Network] > [Network] > [Restart Network] > [Yes]
[Home] key > [Task Screen] > [Wi-Fi Direct]
Press the push button on the computer or handheld device and
select [Push Button] on the screen of operation panel
simultaneously.
The network between this machine and the computer or handheld device is configured.
2-32
Advertisement
Table of Contents
Troubleshooting
