NETGEAR Prosafe GS700TP Software Administration Manual page 51

GS700TP Smart Switch Software Administration Manual
• Defining Trap Generation Parameters
• Providing Access Control Checks
To configure SNMPv1/v2 trap station management:
1. Click System > SNMP > SNMPv1/v2 > Trap Configuration. The SNMPv1/v2 Trap
Configuration screen displays:
Figure 3-10
The SNMPv1/v2 Trap Configuration screen contains the following fields:
• Recipients IP – Enter the IP address to which the traps are sent.
• Notification Type – (Configurable only if the Notification Version is SNMPv2.) Select
the type of notification sent. The possible field values are:
– Traps – Traps are sent.
– Informs – Informs are sent only when SNMPv2 is enabled.
• Community String – Enter the community string of the trap manager.
• Notification Version – Select the trap type. The possible field values are:
– SNMPv1 – SNMP Version 1 traps are sent.
– SNMPv2 – SNMP Version 2c traps are sent.
• UDP Port – Enter the UDP port used to send notifications. The default UDP port is 162.
• Timeout – Enter the amount of time (in seconds) the device waits before re-sending
informs. The default is 15 seconds.
• Retries – Enter the amount of times the device re-sends an inform request. The default is 3
seconds.
2. Select the trap entry.
3-16
v1.0, April 2008
Managing System Settings