NETGEAR Prosafe GS700TP Software Administration Manual page 184

GS700TP Smart Switch Software Administration Manual
– Alert – The second highest warning level. An alert log is saved, if there is a serious
device malfunction; for example, all device features are down.
– Critical – The third highest warning level. A critical log is saved if a critical device
malfunction occurs; for example, two device ports are not functioning, while the rest
of the device ports remain functional.
– Error – A device error has occurred; for example, if a single port is offline.
– Warning – The lowest level of a device warning. The device is functioning, but an
operational problem has occurred.
– Notice – Provides device information.
– Informational – Provides device information.
– Debug – Provides debugging messages.
• Description – Displays the log message text.
2. Click REFRESH or CLEAR LOGS to refresh or reset the Flash Logs screen.
Server Log
The Server Log screen contains information for viewing and configuring the remote log servers.
New log servers can be defined and the log severity sent to each server.
To configure remote log servers:
1. Click Monitoring > Logs > Server Log. The Server Log screen displays:
Figure 7-5
The Server Log screen contains the following fields:
• Server IP – Enter the server's IP address to which logs can be sent.
• UDP Port – Enter the UDP port to which the server logs are sent. The possible range is 1
- 65535. The default value is 514.
Monitoring the Switch
v1.0, April 2008
7-7