Whirlpool Pro-Style Manual page 21

Replace Oven Bake Burner Cover
1. Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
A. Shoulder screw mounting holes (keyholes)
B. Shoulder screws
2. Drop cover and slide to left or right to slide shoulder screws
into narrow ends of keyholes, and lock into place.
A
A. Bake burner cover
Replace Racks
Replace oven racks and the extendable roller rack. See the
"Extendable Roller Rack" section in the Use and Care Guide.
Install Kick Plate
1. Align shoulder screw mounting holes with shoulder screws
on range.
2. Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the
front of the range.
3. Attach screws to the top of the kick plate.
A
A
B
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove burner cap.
3. Remove the burner base.
C
4. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening, and press down onto
the gas orifice spud, then remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice
spud aside.
B
D
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
Large Dual Burner
A
A. Burner cap
B
B. Burner base
Medium Burner
A
A. Burner cap
B
B. Burner base
C. Choke (for use with medium
burner, LP gas only)
A
Small Burner
A. Burner cap
B
B. Burner base
C
21