Whirlpool Pro-Style Manual page 18

Replace Oven Bake Burner Cover
1. Align notches on the oven bake burner cover with shoulder
screws in the bottom of the oven.
A
A. Cover notches (4)
B. Shoulder screws (4)
2. Lower cover and slide to left or right to slide shoulder
screws into the narrow ends of the notches and lock
into place.
A
A. Bake burner cover
Convert Oven Broil Burner (30" [76.2 cm]
and 36" [91.4 cm] models and the Right Oven Cavity
on 48" [121.9 cm] models)
1. Using a Z\v" nut driver, remove broil burner screw
and set aside.
A
B
C
A. Broil burner screw
B. Broil burner
C. Broil burner orifice hole
18
B B
2. Pull the broil burner toward you until it slides out of the hole
in the oven back, and pull the electrode out of the bracket.
The broil burner will hang down in the back of the oven
while you change the orifice.
A
A. Grasp electrode here.
B. Bracket
3. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice
spud aside.
A
A. Oven back
B. Broil burner orifice
C. Broil burner orifice hole
4. Gas orifice studs are stamped with a letter and a number.
Install the Number 148 oven broil burner orifice spud.
5. Place LP gas orifice in plastic parts bag for future use
and keep with package containing literature.
A
A
B
B
Broil burner hanging in
back of oven
B C