Whirlpool Pro-Style Manual page 13

17. Lift up on the control console, and set it back into place.
For a proper fit, the flange of the control console must
hook over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
18. Check that the control console is flush with the top edge
of the range.
A
A. Flush with range top
19. Using a Phillips screwdriver, replace the 2 screws on each
side of the control console.
20. Replace the control knobs.
21. Replace burner grates.
Replace Oven Door
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven
doors.
Failure to do so can result in back or other injury.
1. Using 2 or more people, lift the oven door and insert both
hanger arms into the door. Make sure hanger arm notch
is seated on slot in door frame.
2. Open the oven door part way. You should hear a "click"
as the door is set into place. Then, open the oven door
all the way. Move the hinge levers back to the locked
position.
Slot in frame
Hanger arm
Notch
3. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures.
Reconnect Gas and Electricity
1. Open the manual shut-off valve in the gas supply line.
The valve is open when the handle is parallel to the
gas pipe.
A
A. Closed valve
B. Open valve
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear,
a leak is indicated. Correct any leak found.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug into a grounded 3 prong outlet.
4. Turn on power supply. For further information, please refer
to the user instructions located in the Use and Care Guide.
5. Refer to the "Electronic Ignition System" section in the
Installation Instructions for proper burner ignition, operaion
and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Check flames. Checking for proper cooktop burner flame
is very important. The small inner cone should have a very
distinct blue flame ¼" (0.64 cm) to ½" (1.3 cm) long. The
outer cone is not as distinct as the inner cone. LP gas
flames have a slightly yellow tip.
B
13