GBC HeatSeal Sprint H950 Instruction Manual page 7

© HeatSeal' Sprint" H950 - Load Film
AN Caution, Hot Surfaces A If Possible, load film before running completely out.
STEP 1 NJ STEPS
Cut laminating Insert and lock
film as indicated. Idler Bar Assem-
If film is not bly, then close 4
present see next EZ Load levers.
page.
STEP 2
Open all 4 "EZ"
Load levers and
remove film.
STEP 6
Press feed switch
(forward) and hold
until wrinkle-free
lamination. Close
top.
STEP 3 STEP 7
Remove Idler Bar Scroll up or down
Assembly, then to select film
press "Heat" thickness. Press
button. "Enter" to confirm.
Press "Start" to
resume lamination.
To reset film
thickness, hold
enter button for 5
seconds, select
STEP4 film thickness then
Insert new film,
overlap film on Heat
Shoe.
Note: Match colors of
film core ends to EZ
Load Levers.
press "Enter".