GBC HeatSeal Sprint H950 Instruction Manual page 4

© HeatSeal" Sprint" H950 - Safety
Service
Perform only the routine maintenance procedures referred to in these
instructions.
A Do not attempt to service or repair the laminator.
Unplug the unit and contact an authorized GBC service representative
for any required repairs if one or more of the following has occurred:
* The power supply cord or attachment plug is damaged.
* Liquid has been spilled into the laminator.
* The laminator is malfunctioning after being mishandled.
* The laminator does not operate as described in these instructions.
A vni: THIS в NOT A TOY - DO NOT ALLOW CHILDREN TO OPERATE THIS LAMINATORI
* Shipping damage should be brought to the immediate attention of the
delivering carter.
* Place the laminator on a stable fat surface capable of supporting
110lbs. The surface should be at least 30" high to assure comfortable
positioning during operation. All four rubber feet should be on the
supporting surface.
* Connect power cord to an appropriate power source. Avoid
'connecting other equipment to the same branch circuit to which the
laminator is connected as this may cause nuisance tripping of the
circuit breaker or blown fuses.
Caring for the H-950 Laminator
The only maintenance required by the operator is to periodically clean
the heat shoes. This should only be done when changing fim rolls,
please see page 7 steps 1, 2, & 3. The folowing procedure wil help.
keep the heat shoes free of adhesive that has been deposited along
the edge of the laminating fim.
CAUTION: THE FOLLOWING PROCEDURE IS PERFORMED
WHILE THE LAMINATOR IS HOT. USE EXTREME
CAUTION.
WARNING: Do not apply cleaning fluids or solvents to
the rollers.
WARNING: Do not attempt to laminate adhesives.
marked 'Flammable'.
* The laminator should be positioned to allow exiting film to drop freely
to the floor. Accumulation of laminate as It exits the laminator may
'cause film to wrap around the rollers, causing a jammed condition.
* Avoid placing laminator near sources of heat or cold. Avoid locating
the laminator in the direct path of forced, healed or cooled air.
© Preheat the laminator using the heat button
© Clean the top and bottom heat shoes with a soft cloth.
Ө Follow the procedure on page 7, steps 4, 5, 6 & 7.
NOTE: Do not use metal scouring pads to clean the heat shoes!
WARNING: Do not laminate glitter and/or metalic items, Damage to the
rollers may result.