GBC HeatSeal Sprint H950 Instruction Manual page 13

© HeatSeal' Sprint" H950 - Troubleshooting
SYMPTOMS POSSIBLE CAUSE
CORRECTIVE ACTION
No power switch, does
not illuminate when in
Power cord is not plugged
into live power outlet
Plug into live outlet
pressing standby
button
Faint lines across
the document
Cloudy lamination
Wavy Lamination
Unsatisfactory
adhesion to media
Feeder does not
feed document
Document collection tray
is not fully inserted
Main power switched off
Low film
Machine is not fully warm
Incorrect film setting
Insufficient heat
Media not compatible
Media not compatible
with feeder
Paper is not fully inserted
to feeder
on position Circuit breaker has tripped : Reset circuit breaker at
i rearof machine
Cover is open | Close cover
No paper in feeder i Insert paper
Machine does not Idler bar assemb! i Y
respond after A] y i Latch idler bar levers
Fully insert document
into exit tray
Turn on power
Load new film
Allow time to warm up
Select correct film setting
Verify correct film setting
Media is not suitable
for thermal lamination
Manually feed single
sheets
Fully insert paper to
feeder
Document is skewed
in film
Feeder side guides
not set correctly
Adjust feeder side guides
to paper size
Feeder picks multiple
documents
Static electricity on media, or
media is stuck together
Fan paper and replace
in feeder
Wrinkles in document
EZ Load levers not closed Close EZ Load Levers
13