Sennheiser AMBEO Max Instruction Manual page 31

Disconnecting from the power supply system
▷
Disconnect the power plug of the power cable from the wall
socket.
▷
Unplug the plug of the power cable from the
the Soundbar.
Starting the room calibration
The room calibration is necessary for the measurement of the room
in order to let you get the optimum spatial sound experience.
Therefore, the room calibration should be performed when
• the Soundbar is put into operation for the first time in a room,
• the position of the Soundbar has been changed,
• a subwoofer has been connected or disconnected,
• the room has been changed (e.g. furniture has been moved).
If the "Dolby Virtualizer" is activated, you cannot perform a
room calibration. If necessary, deactivate the "Dolby Virtual-
izer" in the Smart Control app
Preparations for calibration
▷
Connect the Soundbar to the power supply system
The Soundbar switches on. This process takes about 15 seconds.
The status LED pulses white.
▷
Press the on/off button on the top of the Soundbar or the
button on the remote control.
The display shows "Hello" and the prompt "Set up microphone".
Press
On/Off
1x
Putting the AMBEO Soundbar | Max into operation
(> 48).
Hello!
AMBEO Soundbar | Max | 31
POWER socket on
(> 30).
on/off
15s