Basic Settings Page Definitions - Grandstream Networks HT812 Series Administration Manual

Network
Indicates the Status of the Network cables connected to the LAN Port and the WAN Port.
Cable
Status (Up/Down), Speed (Mbps), Operational Mode (Full/Half Duplex)
Status
PPPoE
Indicates PPPoE connection status.
Link Up
NAT Indicates type of NAT when it is configured.
Displays relevant information regarding the FXS ports about their registration, current
Port
Status
status and their appropriate User ID.
Port
Displays relevant information regarding the FXS ports about their DND and call forward features.
Options
Download, Preview. Or, Delete call history records from the web GUI. Only the last 1000 records will be
CDR File
available.
Download, Preview or, Delete locally stored SIP trace.
SIP File
Note: "Send SIP Log" must be enabled to be able to capture the trace.
Provision Displays provisioning status.
Core
Provides generated core dump file if unit malfunctions. Clean will be displayed if no issues.
Dump

Basic Settings Page Definitions

Basic Settings
New End User Password
Confirm End User Password
New Viewer Password
Confirm Viewer Password
Web/SSH Access
Web Session Timeout
Web Access Attempt Limit
Web Lockout Duration
Web Access Mode
HTTP Web Port
HTTPS Web Port
Disable SSH
SSH Port
SSH Idle Timeout
Disable Telnet
Telnet Port
Security Controls for SSH/Telnet
Access
Table 6: Status Page Definitions
Configures user level password. Case sensitive and max. Length of 20 characters.
Note : The new Password must contain 8-20 characters, at least one number, one uppercase,
and a lowercase letter. Purposely not displayed for security reasons.
Re-enter the end user password to confirm change user password on web GUI to avoid typo or
mistakes.
Configures viewer-level password. Case sensitive and max. length of 20 characters.
Note : The new Password must contain 8-20 characters, at least one number, one uppercase,
and a lowercase letter. Purposely not displayed for security reasons.
Re-enter the viewer password to confirm change viewer password on web GUI to avoid typo
or mistakes.
Configure timer to logout web session during idle. Default is 10 min. Range is 2-60 min.
Configure attempt limit before lockout. Default is 5. Range is 1-10.
If login attempt failed 5 times, login would be locked out for the time length. (Default 15
mins. Range 1-15 min).
Allows users to choose the Web Access Mode between "HTTPS", "HTTP" and "Disabled". If
"Disabled" is selected, web UI access will be disabled.
By default, "HTTP" is selected.
Customizes HTTP port used to access the HT801/HT802 web UI. Default is 80.
Customizes HTTPS port used to access the HT801/HT802 web UI. Default is 443.
Enables/disables the SSH access. Default is No (enabled).
Allows users to self-configure SSH Port number.
By default, the port number is 22.
Configures SSH session timeout. [0 – 86400] seconds; Default is 0.
Enables/disables the Telnet access. Default is Yes (disabled).
Allows users to self-configure Telnet Port number. By default, the port number is 23.
Allows the user to choose the security control for SSH or Telnet Access, the options can be :
1. Only allow SSH private IP users to set system Pvalue.
2. Allow all SSH users to set system Pvalue.
3. Allow all SSH users to set any Pvalue.
4. Allow any user to set any Pvalue.
5. Prohibit setting Pvalue.
By default , it is set to "Allow any user to set any Pvalue".