Grandstream Networks HT812 Series Administration Manual page 27

For example: If configured as 617x+, Call Waiting Tone 1 will be used in case of waiting call arrived from the area
code 617. Any other incoming call waiting will be using cadence defined in parameter Call Waiting Tone located
under Advanced Settings Configuration page.
This feature allows user to customize call waiting tone. User has 10 choices.
Syntax: f1=val[,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]]];
Call Waiting (Frequencies are in (300, 3400) Hz and cadence on and off are in (0, 64000) ms)
Tones
Note: The configuration, completed in Distinctive Call Waiting Tones block in the same page, applies to call waiting
cadences configured here.
Default is f1=440@-13,c=300/10000;
Call Features
Settings
When enabled, Do No Disturb, Call Forward and other call features can be used via the local feature codes on the
Enable Call
phone. Otherwise, the ITSP feature codes will be used. Enable All will override all individual features enable setting.
Features
Default is Yes
Reset Call Allows users to reset all call features configuration.
Features
Default is No
Allow users to customize the SRTP feature codes. Default is Yes
SRTP Feature – Enable SRTP: Default is 16
– Disable SRTP: Default is 17
SRTP per call – Enable SRTP per call: Default is 18
Feature – Disable SRTP per call: Default is 19
Allow users to customize the CID feature codes. Default is Yes
CID Feature – Enable CID: Default is 31
– Disable CID: Default is 30
– Enable CID per call: Default is 82
CID per call
Feature – Disable CID per call: Default is 67
Allow users to customize the Direct IP feature code. Default is Yes
Direct IP Calling
Feature – Direct IP Calling: Default is 47
Allow users to customize the CW feature codes. Default is Yes
CW Feature – Enable CW: Default is 51
– Disable CW: Default is 50
– Enable CW per call: Default is 71
CW per call
Feature
– Disable CW per call: Default is 70
Allow users to customize the Call Return feature code. Default is Yes
Call Return
Feature
– Call return: Default is 69
Allow users to customize the Unconditional Forward feature codes.
Unconditional Default is Yes
Forward Feature
– Enable Unconditional Forward: Default is 72
– Disable Unconditional Forward: Default is 73
Allow users to customize the Busy Forward feature codes. Default is Yes
Busy Forward
– Enable Busy Forward: Default is 90
Feature
– Disable Busy Forward: Default is 91
Allow users to customize the Delayed Forward feature codes. Default is Yes
Delayed
– Enable Delayed Forward: Default is 92
Forward Feature
– Disable Delayed Forward: Default is 93
Allow users to customize the Paging feature code. Default is Yes
Paging Feature
– Paging: Default is 74
Allow users to customize the CW feature codes. Default is Yes
DND Feature – Enable DND: Default is 78
– Disable DND: Default is 79
Allow users to customize the Blind Transfer feature code. Default is Yes
Blind Transfer
Feature – Enable Blind Transfer: Default is 87
Default is Yes
Disable LEC per
call Feature – Disable LEC per call: Default is 03
Disable Bellcore
Style 3-Way Default is No
Conference
Star Code 3WC Default is Yes
Feature – Star Code 3WC: Default is 23
Forced Codec Allow users to customize the Forced Codec feature code. Default is Yes
Feature – Forced Codec: Default is 02
PCMU Codec Default is Yes
Feature – PCMU Codec: Default is 7110