Grandstream Networks HT812 Series Administration Manual page 18

2. NAT related info (INFO level)
3. sent or received SIP message (DEBUG level)
4. SIP message summary (INFO level)
5. inbound and outbound calls (INFO level)
6. registration status change (INFO level)
7. negotiated codec (INFO level)
8. Ethernet link up (INFO level)
9. SLIC chip exception (WARNING and ERROR levels)
10. memory exception (ERROR level)
extra syslog style (EXTRA DEBUG level)
Note: A reboot is required to take effect.
Configures whether the SIP log will be included in the syslog messages.
Send SIP Log
The default setting is No.
Allows users to make packet capture including the secret key to decrypt the captured TLS
With Secret Key Information
packets. Default value is No.
Allows the user to start the Information capture process, which can be enabled with a reboot
Information Capture
option every day at a specific time or disabled, Disabled by default.
Always Send HTTP Basic If set to Yes, the device will send configured username and password within HTTP request
Authentication Information without server sending authentication challenge.
Default is No. When "Yes, reboot every day at hour" or "Yes, reboot every week at day" or "Yes,
Automatic Reboot reboot every month at day" is checked, user can specify "Hour of the day (0-23)" or "Day of the
week (0-6)" or "Day of the month (0-30)". Default time is Monday 1AM.
Press Download button to download device configuration file to local computer. The filename is
Download Device Configuration
"config.txt". The file is plain text and not including password fields.
Download Device XML Press Download to download device configuration file to local computer. The filename is
Configuration "config.xml". The file will not include password fields.
Press Upload from local directory button to load the firmware file to the device from your
Upload Firmware computer. The firmware filename should be "ht80xfw.bin" (ht802fw.bin for HT802 for instance),
"ht81xfw.bin" for HT812/HT814 or "ht818fw.bin" for HT818.
Press Upload from local directory button to load configuration file to the device from your
computer. The configuration file should be an XML file (for instance: "config.xml"). Note: The
field
Upload Configuration
is not mandatory in the document but if available only device with specified MAC address will
accept the configuration file.
Press Download button to export device backup configuration to computer.
Export Backup Configuration The output is "cfg<mac>_enc.xml" (where <mac> is the MAC address of the device). The file is
encrypted and can be used on same device only.
Restore From Backup Press Upload button to restore device configuration from previously exported backup
Configuration configuration.
E911/HELD Protocol:
Enable E911 Enable Enhanced 911 call. Default is disabled
HELD Protocol Configure HELD transfer protocol. HTTP or HTTPS
The valid synchronization interval is between 30 to 1440 minutes. The synchronization is off
HELD Synchronization Interval
when the interval is 0.
Location Server Configure the primary Location Information Server (LIS) address
Location Server Username Configure the user name of the primary Location Information Server (LIS)
Location Server Password Configure the password of the primary Location Information Server (LIS)
Secondary Location Server Configure the seconary Location Information Server (LIS) address
Secondary Location Server
Configure the user name of the secondary Location Information Server (LIS)
Username
Secondary Location Server
Configure the password of the secondary Location Information Server (LIS)
Password
HELD Location Types Configure "locationType" element in the location request. "geodetic", "civic" and "location URI"
HELD NAI Configure "locationType" element in the location request. "geodetic", "civic" and "location URI"
HELD Identity 1-10 HELD Identity
HELD Identity 1-10 Value HELD Identity value
E911 Emergency Numbers A user can configure multiple emergency numbers separated with the delimiter symbol ";".
Geolocation-Routing Header If "Yes", E.911 INVITE message includes the "Geolocation-Routing" header with the value "Yes"