Grandstream Networks HT812 Series Administration Manual page 6

Menu Voice Prompt
Main
"Enter a Menu Option"
Menu
"DHCP Mode",
01 "Static IP Mode"
"PPPoE Mode"
02 "IP Address" + IP address
03 "Subnet" + IP address
04 "Gateway" + IP address
05 "DNS Server" + IP address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP Address
Configuration Server IP
14
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
"Check Device Individual
20
Certificate Information"
47 "Direct IP Calling"
86 Voice Mail
99 "RESET"
"Invalid Entry"
"Device not registered"
Options
Press "*" for the next menu option
Press "#" to return to the main menu
Enter 01-05, 07,10, 12-17,47 or 99 menu options
Press "9" to toggle the selection
If using "Static IP Mode", configure the IP address information using menus 02
to 05.
If using "Dynamic IP Mode", all IP address information comes from the DHCP
server automatically after reboot.
If using "PPPoE Mode", configure PPPoE Username and Password from web GUI
to get IP from your ISP.
The current WAN IP address is announced
If using "Static IP Mode", enter 12-digit new IP address. You need to reboot
your HT812/HT814 for the new IP address to take Effect.
Same as menu 02
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
PCM U / PCM A
iLBC
G-726
G-723
G-729
OPUS
G722
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the WAN port and one for
the LAN port. The device MAC address announced is the address of LAN port.
Press "9" to toggle between enable / disable.
Default is disabled.
Announces current Firmware Server IP address. Enter 12-digit new IP address.
Announces current Config Server Path IP address. Enter 12-digit new IP address.
Upgrade protocol for firmware and configuration update. Press "9" to toggle
between TFTP / HTTP / FTP / FTPS or HTTPS. Default is HTTPS.
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the following three
options:
Always check
Check when pre/suffix changes
Never upgrade
The users can now use the IVR system to obtain specific details about the
device's certificate.
Enter the target IP address to make a direct IP call, after dial tone. (See "Make a
Direct IP Call".)
Access to your voice mails messages.
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook If the device is not
registered and the option "Outgoing Call without Registration" is in NO
Table 5: Voice Prompt Menu