Table of Contents
Advertisement
Tools:
– Phillips PH2 / (+) No. 2 screw driver
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
Preliminary steps
▶ Locate the desired server node with the ID button.
▶
"Shutting down the server node" on page
▶ Remove all external cables from the server node.
▶
"Removing server nodes from the server enclosure" on page
▶
"Removing a riser module" on page
▶ If applicable, remove the SFP+ transceiver modules from the expansion
card, see
"Removing SFP+ transceiver modules" on page
Removing an expansion card
▶ If applicable, disconnect internal cables to the expansion card.
▶ Remove the defective expansion card, see
on page
118.
▶ If applicable, remove the TFM from the expansion card, see
TFM" on page
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the board, see
Expansion cards and OCP mezzanine cards
147.
"Installing slot brackets" on page
Upgrade and Maintenance Manual
45.
49.
"Removing expansion cards "
96.
45.
111.
"Removing the
121
Advertisement
Table of Contents
