Recording Time - AT&T CLP99283 User Manual

Answering system
Answering system settings
Using the telephone base:
1. When the telephone base is in idle mode, press
enter the main menu.
2. Press SELECT
3. Press q
CALLER ID
Ans sys setup, then press SELECT.
4. Press q
CALLER ID
Msg alert tone, then press SELECT.
5. Press q
CALLER ID
6. Press SELECT
NOTES:
• The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
• To temporarily turn off the message alert tone, see page 115.

Recording time

You can set the recording time allowed for incoming messages. The message
length is three minutes by default.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset is in idle mode, press
main menu.
2. Press q or p
CID
press SELECT.
3. Press q or p
CID
press SELECT.
4. Press q or p
CID
press SELECT.
5. Press q or p
CID
1 minute, then press
confirmation tone.
to select Answering sys.
or p
DIRECTORY
or p
DIRECTORY
or p
DIRECTORY
to save the setting. You hear a confirmation tone.
to scroll to Answering sys, then
DIR
to scroll to Ans sys setup, then
DIR
to scroll to Recording time, then
DIR
to choose 3 minutes, 2 minutes or
DIR
SELECT to save the setting. You hear a
MENU
to scroll to
to scroll to
to choose On or Off.
MENU to enter the
110
to
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
MSG ALERT TONE
On
Off
BACK
ANS SYS SETUP
Remote code
Msg alert tone
Recording time
BACK
RECORDING TIME
3 minutes
2 minutes
1 minute
BACK
SELECT
SELECT
SELECT
SELECT