7.3.1.3 Interiorpreservation procedure
•
Stop the gear unit.
•
Drain oil into a suitable container (see section 10, "Maintenance and Repair").
•
Unscrew the air filter including the reducing screw.
•
Pour in the preservative agent through the hole of the reducing screw up to the top mark on the oilsight
glass.
For preservative agent see table 9 or 10 in item 4.4.1!
•
Screw in the air filter including reducing screw.
•
Start the gear unit and allow it to idle briefly.
•
Unscrew the oildrain plug.
•
Drain preservative agent into a suitable container.
•
Dispose of preservative agent in accordance with regulations.
There is a risk of scalding from the hot preservative agent draining from the gear unit.
Wear protective gloves!
•
Screw in the oildrain plug.
•
Replace air filter with screw plug.
Before restarting the gear unit, replace the screw plug with the air filter. Observe the
instructions in item 7.1.1.
Gear unit with auxiliary drive:
For interior preservation works on the auxiliary drive the special operating instructions should
be observed.
7.3.2
Exterior preservation
7.3.2.1 Exteriorpreservation procedure
•
Clean the surfaces.
For separation between the sealing lip of the shaftsealing ring and the preservative agent, the
shaft should be brushed with grease in way of the sealing lip.
•
Apply preservative agent.
For preservative agent see table 11 in item 4.4.2!
BA 5030 en 02/2013
80 / 96