7.
Startup
Observe the instructions in section 3, "Safety instructions"!
The gear unit must not be started up if the required instructions are not to hand.
7.1
Procedure before startup
7.1.1
Removal of preservative agent
The location of the oildraining points is marked by an appropriate symbol in the dimensioned drawing in
the gearunit documentation.
Oildraining point:
•
Place suitable containers under the oildraining points.
•
Unscrew the oildrain plug or open the oildrain cock.
•
Remove remaining preservative agent and/or runningin oil from the gear unit using a suitable
container, unscrew any existing residualoil drain plugs, to do so.
•
Dispose of remaining preservative agent and/or runningin oil in accordance with regulations.
Remove any oil spillage immediately with an oilbinding agent.
The oil must not come into contact with the skin (e.g. the operator's hands).
The safety notes on the data sheets for the oil used must be observed here!
•
Screw in the oildrain plug or close the oildrain cock.
•
Screw in any unscrewed residualoildrain plugs again.
A detailed view of the gear unit can be obtained from the drawings in the gearunit documentation.
Fig. 57: Oil inlet / oil drain on gear units type B... ≤ 12
1
BA 5030 en 02/2013
73 / 96
3
2
5
4
8
7
9
6