Re­mounting The Shrink Disk; Inspection Of The Shrink Disk - Siemens FLENDER H SH Series Assembly And Operating Instructions Manual

─ Use a solid lubricant paste with a high MoS
not slide during fitting work and which shows the following characteristics:
─ Friction coefficient "μ" = 0.04
─ Resistant to pressure up to a maximum pressure of 300 N/mm
─ Ageing­resistant
Table 19: Recommended lubricants for shrink disks after their cleaning
Molykote G Rapid
Aemasol MO 19 P
1)
Other lubricants may be used if they have the same characteristics.
• Join inner ring (3) and outer ring (4).
• Place the tensioning bolts and screw in some threads by your fingers.
Observe the manufacturer's instructions for handling lubricants!
Mounting and start­up must be carried out by properly trained specialist personnel.
6.7.4 Re­mounting the shrink disk
For re­mounting the shrink disk the procedure described in item 6.7.1 must be adhered to.
6.7.5

Inspection of the shrink disk

In all cases the inspection relating to the shrink disk should be carried out simultaneously with
the examination of the gear unit, however at least every 12 months.
Inspection of the shrink disk is limited to a visual assessment of its condition. The following must be
observed when carrying out this work:
─ loose screws
─ damage caused by force
─ flush position of the inner ring (3) in relation to outer ring (4)
Lubricant
Unimoly P 5
gleitmo 100
BA 5030 en 02/2013
­based molybdenum disulphide content which will
2
Form
Spray or paste
Spray or paste
Powder
Spray or paste
63 / 96
2
1)
Manufacturer
DOW Corning
A. C. Matthes
Klüber Lubrication
Fuchs Lubritec