AYK550-UH User's Manual
Installation
Study these installation instructions carefully before proceeding. Failure to observe
the warnings and instructions may cause a malfunction or personal hazard.
Warning! Before you begin read "Safety" on page 1.
Installation Flow Chart
The installation of the AYK550 adjustable speed AC drive follows the outline below.
The steps must be carried out in the order shown. At the right of each step are
references to the detailed information needed for the correct installation of the unit.
PREPARE for installation
PREPARE the Mounting Location
REMOVE the front cover
MOUNT the drive
INSTALL wiring
CHECK installation
RE-INSTALL the cover
APPLY power
START-UP
Task
"Preparing for Installation" on page 4.
"Prepare the Mounting Location" on page 9.
"Remove Front Cover" on page 7.
"Mount the Drive" on page 8.
"Install the Wiring" on page 8.
"Check Installation" on page 13.
"Re-install Cover" on page 13.
"Apply Power" on page 17.
"Note! For drives with bypass, if motor is running in
reverse switch incoming power lines at input disconnect."
on page 14.
See
Installation
3