Kohler KG40 Operation page 36

Description
Low cranking voltage
Low engine oil level *
Low engine oil level *
Low fuel level (diesel models)
*
Low fuel level (diesel models)
*
Low fuel pressure (gas
models) *
Low oil pressure
Low oil pressure
No coolant temperature signal
No oil pressure signal
Overcrank
Speed sensor fault
General Functions
Alarm silence, 0- Auto only
(NFPA 110), 1- Always
Aux. inputs 0- 5 VDC,
1 analog
Aux. inputs 0- 5 VDC,
1 analog
Auxiliary inputs, up to 3 digital
(2 additional digital inputs
available with I/O module
option)
Auxiliary inputs, up to 3 digital
(2 additional digital inputs
available with I/O module
option)
Backup parameters loaded
Battery charger 1
communication loss
Battery charger 2
communication loss
Battery charger fault * (does
not apply to charger
GM87448)
Battery charger identity conflict
Battery charger parameter
mismatch
Battery fault
* Function requires optional input sensors or is engine ECM dependent on some generator set models.
† ECM inputs are engine-manufacturer dependent.
‡ Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
** Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term
36
Controller Lamp
Display Alarm Warning
Message Horn Shutdown
Lo Crank Vlt
On
Warning
Oil Level Low
On
Warning
Oil Level Low
On
Shutdwn
Fuel Level Low
On
Warning
Fuel Level Low
On
Shutdwn
Fuel Press Low
On
Warning
Oil Press Low
On
Warning
Oil Press Low
On
Shutdwn
Temp Sig Loss
On
Shutdwn
Press Sig Loss
On
Shutdwn
Over Crank
On
Shutdwn
Spd Sens Flt
On
Warning
Alarm Silence
Mode
Aux Input
On
Warning
Aux Input
On
Shutdwn
Aux Input
On
Warning
Aux Input
On
Shutdwn
Backup Pars
Status
Bat1CommLos
On
s
Bat2CommLos
On
s
Batt Chg Flt On
BatIdErr On
ParMisatch On
Battery Flt On
GenSet
Fault Write Mode
Access Always
Display Running
SiteTech Stopped
W
W
S
W
S
W
W
S
S
S
S
W
S A
W
S
W
W
W
W
W
W
W
Time
Delay
Range Default Range
Setting Selection (sec.)
Fixed 60% Fixed
0-100% 35% 0-10
0-100% 5% 0-10
Fixed
(Fixed
inhibit)
Fixed
(Fixed
inhibit)
Fixed
Fixed
0-1 1
0-100% 100% 0-10
0-100% 100% 0-10
0-10
(0-30
inhibit)
0-10
(0-30
inhibit)
TP-6694
Default
Time
Delay
(sec.)
6
10
0
0
(30
inhibit)
5
(30
inhibit)
5
(30
inhibit)
0
0
0 (0
inhibit)
0 (0
inhibit)
6/22