Adjusting The Handlebar Position - KTM 65 SX 2023 Owner's Manual

10.16

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place handlebar supports in required position. Mount and
tighten screws
C00249-10
Guideline
Screw, handle-
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the installed gaps are even.
TUNING THE CHASSIS 10
1
. Take off the handlebar clamps. Remove
2
. Take off handlebar supports.
2
.
M10 40 Nm (29.5 lbf ft)
M8 20 Nm (14.8 lbf ft)
Loctite ® 243™
1
and tighten
37