12 BRAKE SYSTEM
70
–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
V02822-11
–
Remove screws
–
Press back the brake linings by slightly tilting the brake caliper
laterally on the brake disc. Carefully pull the brake caliper
backward from the brake disc.
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir;
extract some if necessary.
V02824-10
–
Remove cotter pins
–
6
Remove pin
–
Remove the brake linings.
–
Clean the brake caliper.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned in
V02825-10
the holding spring.
–
Position pins
–
Mount cotter pins
Warning
Danger of accidents Oil or grease on the brake discs
reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when nec-
essary.
–
Check the brake discs. (
–
Position the brake caliper.
–
Mount screws
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
V02824-10
1
.
2
3
with membrane
.
4
.
5
.
.
6
.
5
.
p. 65)
4
, but do not tighten yet.
4
.