Connecting Water Supply Hoses to
Screw Type Faucet with Plugs
If a screw type water supply hose is not include in the
product package, then our distribution or installation staff
will provide it to you for free.
Remove the nipple from the end of faucet.
1
• After separating the nipple from the end of
faucet, remove it properly.
Nipple
Connect a screw type intermediate coupling device
2
to the faucet.
• Connect a screw type intermediate coupling
device in such a way that the screw threads are
maintained. If not securely fastened, it can cause
water leakages.
• For further steps, refer to steps 4 through 6 in
Connecting Water Supply Hoses to Rounded
Faucet.
Connecting Water Supply Hoses to
Screw Type Faucet without Plugs
Nipple type
Remove the nipple from the tip of faucet.
• For further steps, refer to 2 to 6 in ʻConnecting Water
Supply Hose to Rounded Faucetʼ.
Nipple
Screw Type
Remove the guide board from the inside of the
connector.
• For further steps, refer to 2 to 6 in ʻConnecting Water
Supply Hose to Rounded Faucetʼ.
Guide
Connecting Water Supply Hoses to Two
Washer
In case that you need to install an additional washer,
you can use necessary accessories as shown below to
connect water supply hoses to two washers.
Separate the water supply hose of the existing
1
washer by disconnecting it from the water faucet.
• For more details, refer to ʻSeparating Water
Supply Hosesʼ.
Intermediate coupling device
Press board
Connect the water supply hose connector to the
2
water supply hose.
Water
supply hose
connector
Press
board
19