Installing Conduction Prevention Brackets (Commencer); Leveling - LG TROMM F2996NCZ Instruction Manual

Installing Conduction Prevention
Brackets (Commencer)
When you install the conduction prevention brackets,
follow the steps in the installation manual and proceed
as follows.
Refer to the installation manual and check the
1
bracket locations.
Bracket location
marked lines
After removing the protection film from the double
2
sided tape attached to the bracket, fix it on the
ground.
Bracket
Double sided tape
Insert the two legs of the product rear into the
3
bracket holes.
WARNING
• For a commencer washer, you have to install the
conduction prevention brackets. If you don't, it can
cause production conduction or injury.
Installation manual
protection film

Leveling

If There is no Auto Height Adjuster
First, check the gap between the four leveling
1
legs and the floor, and use a spanner to level the
product.
Once the leveling legs are adjusted, fix the nuts
2
securely.
Fixing nuts
Leveling
adjusting
legs
If There is an Auto Height Adjuster
Adjust the remaining leveling legs heights until the auto
height adjuster in the product right rear reaches the
height of 2~5 mm.
• Pay attention to make sure that the auto height
adjuster is not lifted above the ground or pressed to
the ground too hard.
• For height adjustment, if you release the bolts
from the auto height adjusting legs, it can cause
malfunctions.
2~5 mm
15