Selecting an Installation Location
Selection a location to install your washer.
• Install it on a firm and flat ground. If not, it can cause
vibrations and noises.
• Make sure that the product is at least 10cm away
from the rear wall and 2cm away from the side wall.
The product front should be cleared for door opening.
10 cm
14
2 cm
2 cm
Removing the Fixing Bolts
Using a spanner, remove the four fixing bolts in the
product rear and block the holes with caps.
• If you need to move the product again, then to protect
the product, you should use the fixing bolts again. So,
keep them in a safe place.
Cap
NOTE
• After removing the fixing bolts in the product rear, you
need to level the product. If not, severe noises and
vibration can cause malfunctions.