In-Camera Charging - Canon ICAM62B Advanced User's Manual

In-Camera Charging

Using USB Power Adapter PD-E1 (sold separately), you can charge Battery
Pack LP-E17 without removing it from the camera. Charging stops if you
operate the camera.
To protect batteries and keep them in optimal condition, do not charge
z
continuously for more than 24 hours.
In case of charging problems, the access lamp blinks in orange and a
z
protective circuit stops charging. In this case, unplug the power cord, reattach
the battery, and wait a few minutes before plugging it in again. If the problem
persists, contact your dealer or nearest Canon Service Center.
556
1
Connect the USB power adapter.
With the camera's power switch set to
z
<2>, insert the USB power adapter
plug fully into the digital terminal.
2
Connect the power cord.
Connect the power cord to the USB
z
power adapter and plug the other end
into a power outlet.
Charging begins, and the access lamp
z
(1) is lit in orange.
When charging is finished, the access
z
lamp turns off. Unplug the power cord
and disconnect the USB power adapter
from the camera.
( 1 )