High Beam Indicator Light; Low Coolant Temperature Indicator Light - Yamaha VK PROFESSIONAL-II 2016 Owner's Manual

Control functions
1
1. Odometer/tripmeter
To reset the tripmeter, push the select/reset
button for at least one second while the trip-
meter is displayed.
TIP
 To switch the speedometer, odometer, and
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the select/reset button for at
least 10 seconds while the snowmobile is
stopped.
 Odometer resets and continues counting
when it reaches 99999 while riding. How-
ever on the 10th time, the odometer will
lock at 99999.
 Tripmeter resets and continues counting
when it reaches 999.9 while riding.
ESU10412

High beam indicator light " "

The high beam indicator light comes on when
the high beams of the headlights are
switched on. (See page 18 for headlight
beam switch operation.)
14
1
1. High beam indicator light "
ESU10474
Low coolant temperature indi-
cator light " "
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally
after the indicator light goes off.
1
1. Low coolant temperature indicator
light " "
TIP
Drive the snowmobile at low speeds when
the low coolant temperature indicator light is
on. If the engine speed is too high, maximum
engine speed is reduced to protect the en-
gine.
"