High Beam Indicator Light; Low Coolant Temperature Indicator Light - Yamaha VENTURE PZ5NXJ Owner's Manual

Odometer, tripmeter, and engine
speed meter modes
1. Odometer/tripmeter/engine speed meter
Odometer shows the total distance that the
vehicle has run.
Tripmeter shows the distance traveled since
it last reset.
Engine speed meter shows the approximate
speed of the engine in revolutions per minute
"r/min".
Pushing the "SELECT" button switches the
display between the odometer mode "ODO",
tripmeter mode "TRIP", and engine speed
meter mode "r/min" in the following order:
ODO → TRIP → r/min → ODO
To reset the tripmeter, push the "RESET"
button for at least 1 second while the tripme-
ter is displayed.
TIP
 Odometer resets and continues counting
when it reaches 99999 while riding.
 Tripmeter resets and continues counting
when it reaches 999.9 while riding.
 To switch the speedometer, odometer, and
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
 Use the engine speed meter only when
checking the snowmobile and performing
basic maintenance. The engine speed me-
ter should not be used while riding the
snowmobile since the reading will vary
from the actual engine speed.
ESU10412

High beam indicator light " "

The high beam indicator light comes on when
1
the high beams of the headlights are
switched on. (See page 18 for headlight
beam switch operation.)
1. High beam indicator light "
ESU10474
Low coolant temperature indi-
cator light " "
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally
after the indicator light goes off.
Control functions
"
13