Yamaha VK PROFESSIONAL-II 2016 Owner's Manual page 32

Control functions
Maximum load limit:
Rear storage area:
5 kg (11 lbs)
Rear carrier:
20 kg (44 lbs)
EWS00141
WARNING
Do not use the rear carrier to lift the snow-
mobile. The snowmobile could fall, which
could result in severe injury or death.
To remove the passenger seat and backrest
1. Open the rider seat. (See "Storage com-
partment" for details.)
2. Remove the passenger seat bolts, slide
the passenger seat and backrest slightly
rearward, and then lift them straight up to
remove them.
2
1. Passenger seat bolt
2. Passenger seat and backrest
3. Install the passenger seat bolts, and then
tighten them to the specified torque.
NOTICE: When using the rear storage
area, do not load any cargo that is too
large for it. In addition, cargo must not
project from the edges of the rear
storage area.
Passenger seat bolt tightening torque:
48 N·m (4.8 kgf·m, 35 lb·ft)
24
[ECS00212]
To install the passenger seat and backrest
1. Open the rider seat. (See "Storage com-
partment" for details.)
2. Remove the passenger seat bolts, insert
the hooks on the bottom of the passen-
ger seat and backrest into the slots in the
rear storage area, and then slide the seat
and backrest forward. NOTICE: Make
sure that the wire harness is not
pinched when installing the passen-
ger seat and backrest.
1. Passenger seat bolt
1
3. Install the passenger seat bolts, and then
tighten them to the specified torque.
[ECS00232]
1