Table of Contents
Advertisement
Control functions
2.
Open the helmet shield heater jack cap,
and then insert the power plug of the hel-
met shield heater into the jack.
1. Helmet shield heater jack
2. Helmet shield heater jack cap
3.
After using the helmet shield heater, be
sure to remove its power plug from the
jack and to close the jack cap.
ECS00893
NOTICE
To avoid circuit overload and a possible
fuse blowing, do not use a helmet shield
heater requiring more than the maximum
rated capacity for the helmet shield heater
jack. (See page 71 for the specified fuse
amperage.)
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU10552
Brake lever
The snowmobile is stopped by braking the
entire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
20
1
1. Brake lever
2
TIP
When the brake lever is squeezed, the brake
light comes on.
ECS00061
NOTICE
Make sure that the brake lever end does
not project out over the handlebar end.
This will help prevent brake lever damage
when the snowmobile is placed on its side
for service.
ESU10582
Parking brake lever
When parking the snowmobile or starting the
engine, apply the parking brake by moving
the parking brake lever to the left.
1. Parking brake lever
To release the parking brake, move the park-
ing brake lever to the right.
Hide quick links:
Advertisement
Table of Contents
