High Beam Indicator Light - Yamaha APEX RX10RY Owner's Manual

Clock
To set the clock
1. Push the "SELECT" button and "RESET"
button simultaneously until the hour digits
start flashing.
1. "SELECT" button
2. "RESET" button
2. Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
3. Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
TIP
The clock must be set again when the battery
is disconnected.
Control functions
Display brightness control
This function allows you to adjust the bright-
ness of the meter display to suit the outdoor
lighting conditions.
To adjust the display brightness
1. Turn the main switch to the off position.
2. Push and hold down the "SELECT" but-
ton.
1. "SELECT" button
2. "RESET" button
3. Display brightness level
3. Turn the main switch to the on position,
and then, after 5 seconds, release the
"SELECT" button.
4. Push the "RESET" button to select the
desired display brightness level, and then
push the "SELECT" button. The normal
display returns when the "SELECT" but-
ton is released.
TIP
If the main switch is turned to the off position
or the engine is started before completing the
procedure, the setting is not applied.
ESU10410

High beam indicator light "

The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 15 for headlight beam switch
operation.)
"
11