Drive Track And Slide Runners - Yamaha VK PROFESSIONAL-II 2016 Owner's Manual

Periodic maintenance and adjustment
1
1. Handlebar bolt
3. Move the handlebar up or down to adjust
the handlebar height to the desired posi-
tion. NOTICE: Make sure that the pro-
jection on the handlebar is not
installed into the area shown.
64
1
1. Area where projection cannot be installed
4.
[ECS00572]
1. Forward
2. Small gap
Handlebar bolt tightening torque:
5.
ESU12179

Drive track and slide runners

Drive track
EWS00482
A broken track, track fittings or debris
thrown by the drive track could be danger-
ous to an operator or bystanders. Observe
the following precautions:
Tighten the front handlebar bolts to the
specified torque, and then tighten the
rear handlebar bolts to the specified
torque. NOTICE: Make sure each han-
dlebar holder is installed so that the
smaller gap is facing forward.
23 N·m (2.3 kgf·m, 17 lb·ft)
Install the handlebar cover.
WARNING
[ECS00583]