Yamaha VK PROFESSIONAL-II 2016 Owner's Manual page 59

Table of Contents

Advertisement

1. Oil filler cap
2. Dipstick
TIP
The engine oil should be between the "H" and
"L" level marks on the dipstick.
1. "H" level mark
2. "L" level mark
6.
If the engine oil is below the "L" level
mark, add sufficient oil of the recom-
mended type to raise it to the "H" level
mark. (See page 80 for the recommend-
ed oil.) NOTICE: When adding the en-
gine oil, be careful not to fill above the
"H" level mark on the dipstick. Use
only the recommended oil. (See page
80.) Make sure that no foreign material
enters the engine oil tank.
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Close the shroud.
Periodic maintenance and adjustment
[ECS00463]
To change the engine oil (with or without oil
filter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Open the shroud.
4.
Remove the right side cover (see page
45 for removal procedures).
5.
Remove the bottom panel by removing
the bolts.
1. Bolt
2. Bottom panel
6.
Place an oil pan under the oil tank to col-
lect the used oil.
7.
Disconnect the oil level gauge coupler.
1
2
1. Oil level gauge coupler
2. Oil filler cap
8.
Remove the oil filler cap and cylinder
head cap, and then remove the engine oil
drain bolt and its gasket to drain the oil
from the oil tank.
1
2
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vk10fh 2016

Table of Contents