Table of Contents
Advertisement
3.2.2.
SNMP Trap Receiver Configuration Menu
Press T (command) on SNMP Configuration Menu, and then you can see SNMP
Trap Receiver Configuration Menu as Figure 3-5. You can implement the configura-
tion of sending SNMP traps on this screen. See section 3.2.1 when configuring the
privilege (read-write/read-only) of the destination for sending SNMP traps.
PNxxxxxx Local Management System
SNMP Configuration -> SNMP Trap Receiver Configuration Menu
Trap Receiver List:
No.
Status
---- --------
1
Enabled
2
Disabled
3
Disabled
4
Disabled
5
Disabled
6
Disabled
7
Disabled
8
Disabled
9
Disabled
10
Disabled
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [S]tatus
Set Trap [T]ype
Command>
Enter the character in square brackets to select option
Figure 3-5: SNMP Trap Receiver Configuration Menu
Screen Description
Trap
Displays the IP address and the community name of a trap-destination, which are
Receiver List
currently configured.
No.
Trap
Status
Type
IP Address
Community
Type
IP Address
-----
---------------
v1
172.16.222.1
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
Set Receiver [I]P
Set Receiver [C]ommunity
Displays the entry number of the trap destination.
Displays if traps need to be sent.
Enable
Sends traps.
Disable
Does not send traps.
Displays the type of traps.
v1
Sends SNMP v1 traps.
v2c
Sends SNMP v2c traps.
Displays a host IP address of an SNMP manager.
Displays the community name, which is currently configured when
sending traps.
26
Community
----------------------------
public
In[d]ividual Trap Config
[Q]uit to previous menu
Advertisement
Table of Contents
