Table of Contents
Advertisement
3.1. System IP Configuration
Press I (command) on the Basic Switch Configuration menu, and then you can see
the System IP Configuration Menu as Figure 3-2. You can configure an IP address
of your device on this screen.
PNxxxxxx Local Management System
Basic Switch Configuration -> System IP Configuration Menu
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
DHCP Mode:
-------------------------------- <COMMAND> -----------------------------------
Set [I]P Address
Set Subnet [M]ask
Set Default [G]ateway
Set IP P[a]rameter
Set [D]HCP Status
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
MAC Address
Displays the MAC address of your device. This cannot be changed by the unique
value on each device.
IP Address
Displays the IP address, which is configured currently. As nothing is set to the
factory default settings, 0.0.0.0 is displayed on the screen.
Subnet Mask
Displays the subnet mask, which is configured currently. As nothing is set to the
factory default settings, 0.0.0.0 is displayed on the screen.
Default
Displays an IP address of the router as the default gateway, which is configured cur-
Gateway
rently. As nothing is set to the factory default settings, 0.0.0.0 is displayed on the
screen.
DHCP Mode
Displays if the mode is configured to require the DHCP server and obtain the IP
address during the startup. The factory default settings is Disabled.
Enabled
Disabled
00:50:40:xx:xx:xx
192.168.1.10
255.255.255.0
0.0.0.0
Disabled
Figure 3-2: System IP Configuration
Requires the DHCP server to obtain the IP address during the start
up.
Does not require to obtain the IP address on the DHCP server
during the start up.
21
Advertisement
Table of Contents
